S-style L | VELLFIRE |
|
VELLFIRE GGH20W | |
![]() |
Code No. 80130-AT205 |
![]() ▲The above photo is an item for GGH30W. |
Pre-load Valve System & M4P Deliver Ultimate Elasticity Ideal for "Low-stance Enthusiasts" |
Application | Specification | |||||||||||||||||||||||||||||||||||||
|
|
Ride Height | mm | ||||||||||||||||||||||||||||
|
*1. Height from road surface to fender arch. *2. Height at factory is the data tested at HKS with the setting of Full Kit. (HKS' recommended setting.) *3. Adjustable range (However, the lowest value may not be road legal. Even within the adjustable range, car body, arm etc. may contact. In such case, it will be hard to drive. Damper oil leakage or any other problems caused by low ride height setting from the factory setting will void the warranty of the product.) *4. Drivable range that there is no contact of car body or arms etc. (However, change of tire/wheel size may cause a problem.) Caution). Actual data depends on each vehicle. |
Kit information | |||||||||||||||||||||||||||||||||||||||||||||||||||||
Spring of Full Kit | |||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||
Specification of damper | |||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||
* The value of the damping force is at piston speed of 0.1m/sec. | |||||||||||||||||||||||||||||||||||||||||||||||||||||
Setting data | |||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||
* Refer to the above explanation *3 of ride height information for drivable high and low limitations. |
Test vehicle information | |||||||||||||||||||||||
|
|||||||||||||||||||||||
* Test data at HKS. |
Parts List * It may be changed without prior notice. |
|
Point |
※The ride height is set for ANH20W before shipment. When installing this product to GGH20W, adjust the dial both front and rear referring to the number of the test result shown in the manual. ※The stabilizer may come in contact with the lower arm if the front case length is extended more than the upper limit. ※The stabilizer may come in contact with the member when turning the steering wheel to the left and right if the front case length is shortened more than the lower limit. ※The parking brake wire may come in contact with the vehicle body if the rear case length is shortened more than the lower limit. ●Modification for Installation The factory rear dust boot is required to be cut off. |
[ CLOSE ]