S-style L | SERENA |
|
SERENA HFC27 | |
![]() |
Code No. 80130-AN202 |
![]() ▲The above photo is an item for E51. |
Pre-load Valve System & M4P Deliver Ultimate Elasticity Ideal for "Low-stance Enthusiasts" |
Application | Specification | |||||||||||||||||||||||||||||||||||||
|
|
Ride Height | mm | ||||||||||||||||||||||||||||
|
*1. Height from road surface to fender arch. *2. Height at factory is the data tested at HKS with the setting of Full Kit. (HKS' recommended setting.) *3. Adjustable range (However, the lowest value may not be road legal. Even within the adjustable range, car body, arm etc. may contact. In such case, it will be hard to drive. Damper oil leakage or any other problems caused by low ride height setting from the factory setting will void the warranty of the product.) *4. Drivable range that there is no contact of car body or arms etc. (However, change of tire/wheel size may cause a problem.) Caution). Actual data depends on each vehicle. |
Kit information | |||||||||||||||||||||||||||||||||||||||||||||||||||||
Spring of Full Kit | |||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||
Specification of damper | |||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||
* The value of the damping force is at piston speed of 0.1m/sec. | |||||||||||||||||||||||||||||||||||||||||||||||||||||
Setting data | |||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||
* Refer to the above explanation *3 of ride height information for drivable high and low limitations. |
Test vehicle information | |||||||||||||||||||||||
|
|||||||||||||||||||||||
* Test data at HKS. |
Parts List * It may be changed without prior notice. |
|
Point |
・With this product, the floating feeling and vehicle body roll are reduced to deliver stable driving feeling that enables a driver to enjoy driving. ・The dial position during the test: Front – 12 / Rear – 12 (Recommended dial position) ・For the rear side, even with factory wheels, the tire comes in contact with the fender due to the limit of vehicle side’s arm. ・With the factory wheels, the ground clearance is lowered approximately by 10mm. → The ground clearance was secured with the factory wheels at the time of testing; however, the actual clearance may vary depending on an individual difference of vehicles. |
[ CLOSE ]