MAX IV GT
ALTEZZA
ALTEZZA GXE10

MAX IV GT

Code No. 80230-AT006

*Discontinued.

Awesome control and comfort ride on the street for a sporty drive. The new Max IV sporty suspension.

 

 

▲The model in the photo is SXE10.

 

 

Application

Engine 1G-FE
Model Year 98/10 - 05/07
Remarks The vehicle height data is of SXE10(ALTEZZA).

Specification

  FRONT REAR
Damping force adjustment 30 steps 30 steps
Base valve - -
Height adjustable lower bracket
Upper mount Rubber Rubber
Inverted/Normal type Normal Normal
Damper/Spring layout Coilover Coilover
Spring rate change at factory Possible Possible
Damping force adjustment with wire -
Helper spring
(Spring rate N/mm)
○ ( 19.8 ) ○ ( 19.8 )
Ride Height mm
  Factory *2 Test data Adjustable range
High - Low *3
Drivable range
High - Low *4
FRONT Ride height *1 633 674 ~ 603 649 ~ 603
Against stock -41 0 ~ -71 -25 ~ -71
REAR Ride height *1 634 668 ~ 559 668 ~ 559
Against stock -34 0 ~ -109 0 ~ -109

*1. Height from road surface to fender arch.
*2. Height at factory is the data tested at HKS with the setting of Full Kit. (HKS' recommended setting.)
*3. Adjustable range (However, the lowest value may not be road legal.
Even within the adjustable range, car body, arm etc. may contact. In such case, it will be hard to drive.
Damper oil leakage or any other problems caused by low ride height setting from the factory setting will void the warranty of the product.)
*4. Drivable range that there is no contact of car body or arms etc. (However, change of tire/wheel size may cause a problem.)
Caution). Actual data depends on each vehicle.


Kit information

Spring of Full Kit

  F R
Spring rate N/mm(kgf/mm) 98 ( 10 ) 78 ( 8 )
Free height (mm) 170 200
Spring type Straight Straight
Recommended range to change spring rate N/mm(kgf/mm) ±20 ( 2 ) ±20 ( 2 )

Specification of damper

  F R
Damping force (Rebound/Damping)N* 1775 / 441 1049 / 177
Default position of dial 15 15
Remaining damper stroke (Rebound/Damping)mm 44 / 41 59 / 56

* The value of the damping force is at piston speed of 0.1m/sec.

Setting data

  F R
Default Test Drivable limit
High *
Drivable limit
Low *
Default Test Drivable limit
High *
Drivable limit
Low *
Length of
case (mm)
355 365 347 407 420 383
Spring
Set length(mm)
196 196 207 244 241 270
Length to ride hight
adjuster (mm)
81 91 62 65 88 15
Lever ratio 1.57 1.50

* Refer to the above explanation *3 of ride height information for drivable high and low limitations.



Test vehicle information

  F R
Vehicle weight kg 735 (740) 636 (620)
Tire size (Air pressure) kPa 215 / 45 - 17 ( 230 ) 215 / 45 - 17 ( 230 )
Wheel size 7 JJ × 17 off 50 7 JJ × 17 off 50
Alignment
(Toe/Camber)
Test data 0 mm / -1°12' in 3 mm / -2°00'
Standard value in 1 ± 2 mm / -0°30' ± 45' in 2 ± 2 mm / -0°55' ± 45'

* Test data at HKS.


Parts List  * It may be changed without prior notice.

 


Point

・This is for both sport and comfort in driving performance.
・Set the dial at 15 step for both front and back for town drive.
・If the front case size is less than 347mm, upper and body might interfere with each other in full bump.
・If the rear case is less than 383mm, upper and body might interfere with each other in full bump.
・The vehicle height data from other than the test is computational data.(The numbers does not guaranteeing the height)
 
●Process for installation
Required to make an hole for rear damping adjustment cable(trunk interior)
 
 
 



[ CLOSE ]

 

 

HKS