MAX IV GT
SUPRA
SUPRA JZA80

MAX IV GT

Code No. 80230-AT010

*Discontinued.

Awesome control and comfort ride on the street for a sporty drive. The new Max IV sporty suspension.

 

 

▲The model in the photo is JZA80.

 

 

Application

Engine 2JZ-GTE
Model Year 93/06 - 02/07
Remarks REAS installed vehicle can't use

Specification

  FRONT REAR
Damping force adjustment 30 steps 30 steps
Base valve - -
Height adjustable lower bracket
Upper mount Rubber Rubber
Inverted/Normal type Normal Normal
Damper/Spring layout Coilover Coilover
Spring rate change at factory Possible Possible
Damping force adjustment with wire - -
Helper spring
(Spring rate N/mm)
○ ( 19.8 ) ○ ( 19.8 )
Ride Height mm
  Factory *2 Test data Adjustable range
High - Low *3
Drivable range
High - Low *4
FRONT Ride height *1 650 692 ~ 598 692 ~ 607
Against stock -42 0 ~ -94 0 ~ -85
REAR Ride height *1 645 668 ~ 563 668 ~ 602
Against stock -23 0 ~ -105 0 ~ -66

*1. Height from road surface to fender arch.
*2. Height at factory is the data tested at HKS with the setting of Full Kit. (HKS' recommended setting.)
*3. Adjustable range (However, the lowest value may not be road legal.
Even within the adjustable range, car body, arm etc. may contact. In such case, it will be hard to drive.
Damper oil leakage or any other problems caused by low ride height setting from the factory setting will void the warranty of the product.)
*4. Drivable range that there is no contact of car body or arms etc. (However, change of tire/wheel size may cause a problem.)
Caution). Actual data depends on each vehicle.


Kit information

Spring of Full Kit

  F R
Spring rate N/mm(kgf/mm) 137 ( 14 ) 79 ( 8 )
Free height (mm) 200 200
Spring type Straight Straight
Recommended range to change spring rate N/mm(kgf/mm) ±20 ( 2 ) ±20 ( 2 )

Specification of damper

  F R
Damping force (Rebound/Damping)N* 2350 / 400 1000 / 200
Default position of dial 15 15
Remaining damper stroke (Rebound/Damping)mm 41 / 49 80 / 56

* The value of the damping force is at piston speed of 0.1m/sec.

Setting data

  F R
Default Test Drivable limit
High *
Drivable limit
Low *
Default Test Drivable limit
High *
Drivable limit
Low *
Length of
case (mm)
373 397 368 385 408 354
Spring
Set length(mm)
221 221 240 269 269 271
Length to ride hight
adjuster (mm)
29 53 5 33 56 0
Lever ratio 1.78 1.31

* Refer to the above explanation *3 of ride height information for drivable high and low limitations.



Test vehicle information

  F R
Vehicle weight kg 837 (830) 693 (680)
Tire size (Air pressure) kPa 235 / 40 - 18 ( 200 ) 265 / 35 - 18 ( 200 )
Wheel size 9 JJ × 18 off 38 10 JJ × 18 off 45
Alignment
(Toe/Camber)
Test data 0 mm / -2°30' 0 mm / -2°00'
Standard value 0 ± 1 mm / -0°20' ± 30' in 3 ± 1 mm / -1°35' ± 30'

* Test data at HKS.


Parts List  * It may be changed without prior notice.

 


Point

We have made the newest technology of MAX IV GT for JZA80 for the best driving experience for both comfort and sport.
With the newest technology of MAX IV GT into JZA80 can make the drive fast and comfortable. We have set the goal of MAX IV to have both driving performance and comfort. Therefore HKS has analyzed and test the transient characteristic, not the general pin point so we could develop the suspension that has firmness and still comfortable damping feeling. For this result we have redesigned needle and developed variant port system that greatly improved the damping characteristic of driving feeling at a low speed.
For JZA80, stiff feeling of stock has improved, and luxurious handling by reducing the big behavior change.
It has damping but not so stiff and feel comfortable. It is smooth but does not float and stick to the ground. It fits wide range of driving conditions with one dial setting. And also it can drive from the street to circuit race by changing the dial.
 
 
 
 
 
 
 



[ CLOSE ]

 

 

HKS