MAX IV GT
SAI
SAI AZK10

MAX IV GT

Code No. 80230-AT012

*Discontinued.

Awesome control and comfort ride on the street for a sporty drive. The new Max IV sporty suspension.

 

 

▲The model in the photo is AZK10.

 

 

Application

Engine 2AZ-FXE(2AZ-2JM)
Model Year 09/12 - 17/11
Remarks  

Specification

  FRONT REAR
Damping force adjustment 30 steps 30 steps
Base valve - -
Height adjustable lower bracket
Upper mount Rubber Stock
Inverted/Normal type Inverted Normal
Damper/Spring layout Coilover Separated
Spring rate change at factory Possible Possible
Damping force adjustment with wire - -
Helper spring
(Spring rate N/mm)
- -
Ride Height mm
  Factory *2 Test data Adjustable range
High - Low *3
Drivable range
High - Low *4
FRONT Ride height *1 640 648 687 ~ 619 687 ~ 619
Against stock -47 -39 0 ~ -68 0 ~ -68
REAR Ride height *1 649 683 ~ 627 683 ~ 627
Against stock -34 0 ~ -56 0 ~ -56

*1. Height from road surface to fender arch.
*2. Height at factory is the data tested at HKS with the setting of Full Kit. (HKS' recommended setting.)
*3. Adjustable range (However, the lowest value may not be road legal.
Even within the adjustable range, car body, arm etc. may contact. In such case, it will be hard to drive.
Damper oil leakage or any other problems caused by low ride height setting from the factory setting will void the warranty of the product.)
*4. Drivable range that there is no contact of car body or arms etc. (However, change of tire/wheel size may cause a problem.)
Caution). Actual data depends on each vehicle.


Kit information

Spring of Full Kit

  F R
Spring rate N/mm(kgf/mm) 49 ( 5 ) 49 ( 5 )
Free height (mm) 220 200
Spring type Straight Barrel type Straight Barrel type
Recommended range to change spring rate N/mm(kgf/mm) ±20 ( 2 ) +10 ( 1 )

Specification of damper

  F R
Damping force (Rebound/Damping)N* 481 / 147 284 / 177
Default position of dial 15 15
Remaining damper stroke (Rebound/Damping)mm 53 / 60 84 / 76

* The value of the damping force is at piston speed of 0.1m/sec.

Setting data

  F R
Default Test Drivable limit
High *
Drivable limit
Low *
Default Test Drivable limit
High *
Drivable limit
Low *
Length of
case (mm)
310 310 348 310 361 392 341
Spring
Set length(mm)
200 192 193 220 - - - -
Length to ride hight
adjuster (mm)
47 55 92 27 42 62 29
Lever ratio 1.04 1.67(spg) , 1.11(dmp)

* Refer to the above explanation *3 of ride height information for drivable high and low limitations.



Test vehicle information

  F R
Vehicle weight kg - (990) - (620)
Tire size (Air pressure) kPa 215 / 45 - 18 ( 250 ) 215 / 45 - 18 ( 230 )
Wheel size 7.0 JJ × 18 inset 51 7.0 JJ × 18 inset 51
Alignment
(Toe/Camber)
Test data in 2 mm / -0°55' in 2 mm / -2°20'
Standard value in 2 ± 2 mm / -0°15' ± 45' in 2 ± 2 mm / -1°05' ± 45'

* Test data at HKS.


Parts List  * It may be changed without prior notice.

 


Point

・The setting of this product focuses on the improvement of sport performance and stable ride feeling
・The ride performance is enhanced by reducing the feeling of floating, so it is the best for those who look for the stable driving on highways.
・If the front case length is shortened less than 310mm, the stabilizer link may come in contact with the damper at full-stroke and/or steering.
・If the front case length is extended more than 348mm, the stabilizer link may come in contact with the lower arm at full extension.
・If the rear case length is shortened less than 341mm, the arms may come in contact with the vehicle body at full-stroke and/or steering.
 
 
 
 
 
 



[ CLOSE ]

 

 

HKS